13,420
edits
Changes
no edit summary
# You basically follow the install procedure, but I will include subtle areas and recommended settings:
:# '''Select "Third Party Applications"''' in one of the initial installation screen.
:# '''Select the LTSP option, and select . Make certain that the "eth0 interface is connected" network interface card. '''. The other LTSP 1) will use the next available network interface card will be connected (i.e. eth1) to connect to the switch that will, in turn, are connected connect to the workstations (thin clients).
:# '''I would recommend an advanced partitioning if you have more than one hard disk'''. The current system has two hard disk drives. The first drive is the main system under the mount-point called "/" and the second hard drive has the mount-point called /backup for backing up the system. By correctly specifying these mount-points at this point will allow the system to identify and use these directories when the system is in use. Here are the recommended settings:<br /><br />'''Hard drive A''' (/dev/sda): '''Add swap partition''' (double size for amount of RAM), and '''add remaining partition''' as file-system called '''ext4''' with the mount-point called: '''/'''<br /><br />'''Hard drive B''' (/dev/sdb): '''Add entire file-system''' called '''ext4''' with the mount-point called: '''/backup'''<br /><br />
:# '''Create an administrator account''' (do NOT use the username "admin" (that name is already taken) ).