1,885
edits
Changes
→Format of an Assembly Language program
# Data - Values used by the program for things such as initial variable values and string or numeric constants.
Assembler '''directives''' are used to control the assembly of the code, by specifying output file sections (such as .text (machine code), .data (read/write data), or .rodata (read-only data /constants) in an ELF file) and data formats (such as word size for numeric values), and by defining macros.
Consider this x86_64 assembly language "Hello World" program:
<font color="green">mov</font> $<font color="blue">msg</font>,%<font color="blue">rsi</font> /* message location */
<font color="green">mov</font> $<font color="blue">stdout</font>,%<font color="blue">rdi</font> /* file descriptor stdout */
<font color="green">mov</font> $<font color="orange">1</font>,%<font color="blue">rax</font> /* [[Syscalls|syscall ]] sys_write */
<font color="green">syscall</font>
<font color="green">syscall</font>
<font color="red">.datarodata</font>
<font color="blue">msg:</font> <font color="red">.ascii</font> <font color="orange">"Hello, world!\n"</font>
In the program above:
* .text is a directive (equivalent to the longer directive ".section .text") which specifies that the following instructions/data should be placed in the ".text" section of the output ELF file.
* .data rodata is a similar directive which specifies that the following instructions/data should be placed in the .data rodata section of the output ELF file. In the case of this program, they could alternately be placed in the .rodata data section, which is for read-only write data (data which is write-protected in memory), but .rodata was used because the string is not modified by the program(it's a constant).
* .global (or .globl) is a directive which makes the following symbol visible to the linker. Otherwise, symbols are normally lost by link time. In this case, the linker needs to know the value of the special symbol _start in order to know where execution is to begin in the program (which is not always at the start of the .text section).
* _start is a label which is equivalent to the memory location of the first instruction in the program.
On a Linux system, you will need to meet three requirements to get your assembly language program to work:
# Code must be placed in the <code>.text</code> section of the ELF file.# Data must be placed in either the <code>.rodata</code> (read-only data) or <code>.data</code> (read/write data) sections of the ELF file.# There must be a globally-defined symbol which the linker (<code>ld</code>) will use to find the entry point to your program. If the code is being directly compiled by the assembler, this symbol must be <code>_start</code> -- but if the code is being compiled by gcc, this symbol must be called <code>main</code>(a preamble will be located at <code>_start</code> which will then transfer control to <code>main</code>).
The file extension should be <code>.s</code> for assembler source without directives (for compilation with the assembler) or <code>.S</code> for assembler with preprocessor directives (for compilation with gcc).
