Changes

Jump to: navigation, search

Raspberry Pi Interfacing

8 bytes removed, 23:40, 25 September 2012
Available Interfaces
* [http://en.wikipedia.org/wiki/Composite_video Composite video] ([http://en.wikipedia.org/wiki/Ntsc NTSC/NTSC-J] or [http://en.wikipedia.org/wiki/PAL PAL/PAL-M] format). This output can be used to drive older video monitors, or small composite LCD displays.
* [http://en.wikipedia.org/wiki/Analog_signal Analog] [http://en.wikipedia.org/wiki/Stereo stereo] audio (on a 3.5 mm (1/8") [http://en.wikipedia.org/wiki/TRS_connector TRS] jack).
* [http://en.wikipedia.org/wiki/Pin_header Pin header] exposing [http://en.wikipedia.org/wiki/GPIO GPIO], [http://en.wikipedia.org/wiki/Serial_Peripheral_Interface_Bus SPI], [http://en.wikipedia.org/wiki/I%C2%B2C I2C], [http://en.wikipedia.org/wiki/Serial_port serial], and (in board revision 2) [http://en.wikipedia.org/wiki/Jtag#Boundary_scan_testing JTAG]. All of these signals are provided at TTL 3v3 (+3.3 volts DC (VDC) +/-10% for a logical "high" or "1", 0 VDC for a logical "low" or "0"). A +5 VDC (+/-5%) supply is also provided.
* [http://en.wikipedia.org/wiki/Camera_interface CSI] - Camera serial interface. The connector accepts a [fttp://en.wikipedia.org/wiki/Flexible_flat_cable flexible flat cable].
* [http://en.wikipedia.org/wiki/Display_Serial_Interface DSI] - Display serial interface, for connection to a small LCD panel or similar interface. The connector accepts a [fttp://en.wikipedia.org/wiki/Flexible_flat_cable flexible flat cable].

Navigation menu