Changes

<ol><li value="7">'''Step 4 of 5:''' This next step creates a disk file that will be used to simulate the virtual machine's disk drive. Select a size of '''10 GB'''. Click on<br> '''Select managed or other existing storage''' and type the VM image file pathame:<br> '''/var/lib/libvirt/images/centos1.qcow2''' (make certain that the pathname is correct) and then click '''Forward''' to proceed.</li><li>'''Step 5 of 5:''' Enter the virtual machine name: '''centos1'''. Review the VM information, and click '''Finish'''.<br><br></li><li>'''The virtual machine will now start''' - start timing your installation and making notes for '''centos1''' virtual machine in the installation comparison chart in lab2 logbook. The virtual machine is running from the live disc at this point, and no software has been installed on the ''hard drive'' of the virtual machine. The point of a live disk is to allow you to test the distribution to see whether you like it without installing to the hard-drive first.</li><li>Double-click '''Install to Hard Drive'''. The installation program, similar to the one used when installing CentOS in Lab 1, will appear. You basically perform the same installation operations for this VM including for '''Date & Time''', '''Network & Hostname''', and '''Installation Destination'''. Make certain to use the '''hostname''': '''<u>centos1</u>''' as opposed to ''c7host'') for this installation. (with a few slight differences).</li><li>For '''Installation Destination''', select the destination option: '''I will configure partitioning''' and then click '''Done'''. Make certain that the '''Partition Scheme''' is set to '''LVM''' and then click on the link: '''Click to Create Automatically'''. '''Done'''. Check to make certain that the root partition has file system type: '''ext4'''.</li><li>Accept the changes and then click '''Begin Installation'''.<ol type="a"><li>You will be required to make selections very similar to what you did in lab1.</li><li>While the system is installing, take a few minutes to record your observations (including slight differences with centos1 install as opposed to c7host install).</li><li>When the installation process is complete, note the time required to install this system and record in the installation comparison chart of your lab2 logbook.<br><br></li></ol></li><li>Power-off your Centos7 LIVE system.</li><li>You should notice that the Centos7 boot menu appears. Either press '''ENTER''' to start or wait for it to start automatically.</li><li>Finish the final steps in the setup process (like you did in lab1).</li><li>#You may want to turn off the screen-saver (like you did in Lab1): [http://zenit.senecac.on.ca/wiki/index.php/OPS235_Lab_1_-_CentOS7#Customizing_Your_Account How to Turn-off Screen Saver (lab1)]</li></ol>