<ol><li value="6">Confirm the user you created has been added using the following command:<br>'''pdbedit -L -v'''</li><li>Test and review your configuration with the command:<br>'''testparm'''</li><li>Use the '''systemctl''' command to start the smb.service and enable the service to run on boot-up</li><li>If you are in one of the sections with SELinux set to enforcing, you will need to tell it to allow samba access to home directories: '''setsebool -P samba_enable_home_dirs 1'''</li><li>Install Use the ''netstat'' command by issuing the following command:<br>'''yum install net-tools'''</li><li>Issue the '''netstat ss -nautp''' command to see with port Samba is running on.</li><li>Use the information in the previous step to modify the firewall on VM2 machine to allow samba traffic.</li><li>Test to see that you can connect to your Samba server (locally) by issuing the following command:<br>'''smbclient -U <yourSenecaID> -L 127.0.0.1'''</li><li>When prompted, enter your Samba account password.</li><li>The output from that issued command show appear similar to example displayed below:</li></ol>