Winter 2010 Posters/SheevaPlug Configuration
Project Name
SheevaPlug Configuration
Names
Alex Vlahopoulos
The SheevaPlug Hardware Specifications
Sheeva CPU Core
1.2 GHz operation
L1 Cache: 16K Instruction + 16K Data
L2 Cache: 256KB
Memory
DDR2 400MHz, 16-bit bus
512MB DDR2: 1Gb x8, 4 devices
Power efficient Samsung devices
NAND FLASH Controller, 8-bit bus
512MB NAND FLASH: 4Gb x8, direct boot
128-bit eFuse Memory
Power
Power input: 100-240VAC/50-60Hz 19W DC Consumption: 5V/3.0A High efficiency POL DC-DC converters
Development Interface
System Development Board JTAG and Console Interface via USB SDIO expansion JTAG OpenOCD support via USB
High Speed I/O & Peripherals
GE, USB 2.0 Host RTC w/ Battery
The Goal
The goal of this project was to successfully run Fedora 12 on the SheevaPlug.
Challenges
1. 512MB NAND is too small to install a regular installation of Fedora 12 on (The plug has no disk) 2. The plug does not have a BIOS
Solutions
1. In order to run Fedora 12 on the SheevaPlug I had to install the operating system on an SD card (although it can also be installed on a USB drive). 2. Since there is no BIOS to select which device gets booted, the SheevaPlug has a bootloader called U-boot. However, U-boot needed to be upgraded and configured for the SD card to be selected during the boot up process.
Acknowledgements
Chris Tyler
Links
- Fedora Project - http://fedoraproject.org/wiki/Architectures/ARM/PlatformSheevaplug
- Instructables (HOW-TO-PAGE) - http://www.instructables.com/id/How-to-install-Fedora-on-a-SheevaPlug-and-boot-off/
- U-Boot Upgrading (HOT-TO-PAGE)- http://www.cyrius.com/debian/kirkwood/sheevaplug/uboot-upgrade.html
Logos
- Fedora
- Seneca