Fall 2008 NAD710 Weekly Schedule
The tentative weekly schedule shown here is subject to change.
Week 1 (Sept 1) - Intro to Networking / IP Network Basics
Lecture
- Program Introduction - by Prof. John Selmys
- Course Introduction - by Prof. Raymond Chan
- Lectures and Labs
- Introduction to Networking
- Network Types
- Network Models
- OSI Reference Model
- TCP/IP Network Model
- IP Networking Basics
- The Client-Server Model
- Request for Comment
- Institute of Electrical and Electronics Engineers (IEEE)
- The Internet, TCP/IP, and other protocol stacks
Lab 1
Week 2 (Sept 8) - Manual network configuration
Lecture
- Network drivers and loadable kernel modules
- Identify the network device name - ifconfig/ip
- IP Address, Broadcast Address and Network Mask
- IP Address Class
- Private IP address space
- Display the kernel's address resolution table
- Check the network connectivity to other machines
- Display kernel routing table
Lab 2
Week 3 (Sept 15) - Sysconfig network configuration
Reading
Ethernet Hub
A network hub or repeater hub is a device for connecting multiple twisted pair or fiber optic Ethernet devices together, making them act as a single network segment. Hubs work at the physical layer (layer 1) of the OSI model. The device is thus a form of multiport repeater. Repeater hubs also participate in collision detection, forwarding a jam signal to all ports if it detects a collision.
Hubs also often come with a BNC and/or AUI connector to allow connection to legacy 10BASE2 or 10BASE5 network segments. The availability of low-priced network switches has largely rendered hubs obsolete but they are still seen in older installations and more specialized applications. More on Wikipedia...
Network Switch
A network switch is a broad and imprecise marketing term for a computer networking device that connects network segments.
The term commonly refers to a Network bridge that processes and routes data at the Data link layer (layer 2) of the OSI model. Switches that additionally process data at the Network layer (layer 3) (and above) are often referred to as Layer 3 switches or Multilayer switches.
The term Network switch does not generally encompass unintelligent or passive network devices such as hubs and repeaters.
The first Ethernet switch was introduced by Kalpana in 1989. More on Wikipedia ...
Network Router
A router (pronounced /'rautər/ in the USA, pronounced /'ru:tər/ in the UK, or either pronunciation in Australia) is a computer whose software and hardware are usually tailored to the tasks of routing and forwarding information. More on Wikipedia ...
Lecture
- Network Communication by Name - /etc/hosts, /etc/resolv.conf
- Configure Network Name services - nsswitch.conf (Name Service Switch configuration)
- Using DNS servers: how and why
- Check the network connectivity to other machines
- Show active sockets, interfaces, and routing information
- Connect to hosts on your local network
- Connect to hosts on different networks with specific routes/gateways
- Connect to the Internet - Default Gateway
Sysconfig network configuration
- To start the the program:
- click on the menu bar "system->Administration->Network"
- type at the command line "system-config-network"
Lab 3
Week 4 (Sept 22) - NetworkManager
Lecture
NetworkManager Project Web Site
Red Hat Article on NetworkManager
- Note that the repository for the NetworkManager source code has been moved from cvs to subversion (svn). Details can be found here.
NetworkManager
- A service daemon that attempts to keep an active network connection available at all times.
- makes networking configuration and setup painless and automatics as possible.
- NetworkManagerDispatcher
- nm-tool - provides information about NetworkManager, device, and wireless networks.
[rchan@rh9 ~]$ nm-tool
NetworkManager Tool
State: connected
- Device: eth0 ----------------------------------------------------------------
Type: Wired
Driver: r8169
State: connected
HW Address: 00:1B:38:12:E2:33
Capabilities:
Supported: yes
Carrier Detect: yes
Speed: 100 Mb/s
Wired Settings
IP Settings:
IP Address: 192.168.0.200
Subnet Mask: 255.255.255.0
Broadcast: 192.168.0.255
Gateway: 192.168.0.1
DNS: 192.168.0.1
- Device: wlan0 ----------------------------------------------------------------
Type: 802.11 Wireless
Driver: iwl4965
State: disconnected
HW Address: 00:00:00:00:00:00
Capabilities:
Supported: yes
Wireless Settings
WEP Encryption: yes
WPA Encryption: yes
WPA2 Encryption: yes
Wireless Access Points
- NetworkManager Administration
- Check the service daemon status
[root@fc9 ~]# service NetworkManager status NetworkManager (pid 2239) is running...
- Stop the service daemon (Don't do this if you are connected to the system remotely. If you do, you will get cut off.)
[root@fc9 ~]# service NetworkManager Stop Stopping NetworkManager daemon: [ OK ]
- Start he service daemon
[root@fc9 ~]# service NetworkManager Start Setting network parameters... [ OK ] Starting NetworkManager daemon: [ OK ]
Lab 4
Week 5 (Sept 29) - Nameserver configuration
Lecture
- Different type of Domain Name Servers
- Caching only Name Server
- Primary Name Server
- Secondary Name Server
- Free and Open Source Software for running a DNS - BIND
- BIND source codes and Binary
- Source code can be download from the ISC web site
- Installation
- Standard/Normal installation
- Chroot installation
- BIND Configuration file(s)
- Main configuration file - named.conf
- zone file(s) - depends on the setup in named.conf
- Forward lookup zone file(s)
- Reverse lookup zone file(s)
- Starting and Stopping a BIND DNS
- BIND DNS maintanence
- BIND source codes and Binary
- Basic Operation of the Internet Domain Name System
- Name Server and Resolver
- Name Server Configuration
- Resolve Configuration
- DNS queries and responses
- Recursive and non-recursive queries
- Authoritative and non-authoritative responses
Lab
Week 6 (Oct 6) - NFS I
Week 7 (Oct 13) - NFS II
FSOSS and Break Week (Oct 20)
Week 8 (Oct 27) - Midterm Test and Samba I
Midterm Test: October 28, 2008
- All material covered from week 1 to week 7
- Lab 1 to Lab 7
- Close Book