OPS335 Installation Lab
Installation of Fedora 14
Objectives
Installing Fedora 14
Instructions
- Download a copy of Fedora 13 Live CD 64 bit edition from FedoraProject.Org web site or burn the CD using Seneca's Freedom Toaster which is located in the Open Lab on the 2nd floor of the TEL building. Note: we'll be using the 64 bit version of Fedora otherwise known as x86_64 Fedora because all of our lab computers are equiped with Intel 64 bit mainboards and CPUs. Also, we'll be using the Live CD for installation because it's much simpiler and quicker to install a basic Fedora Linux system on a hard drive. Finally, if you're going to burn your CD using the Freedom Toaster then be sure to use a blank CD-R disk. For some reason CD+R disks sometimes fail to burn successfully.
- Purchase a SATA (Serial Advanced Technology Attachment) removable HDD (Hard Disk Drive) with a minimum of 80 GB capacity from Seneca's bookstore located on the first floor of the SEQ building. I strongly recommend you use this disk drive exclusively for this course. If another course requires a similar HDD you should purchase a separate one and not attempt to use one disk drive for both courses.
Insert your HDD into the docking bay of a PC in the lab and boot the computer using your Fedora Live CD. If possible try to use the same PC for this course for the rest of the semester. Some PCs may be configured with slight hardware variations from others which may cause problems when moving your HDD from one system to another. Once Fedora has loaded, start Firefox and ensure the network is functioning. You will need to authenticate yourself with your LEARN user name and password before Internet access is allowed to the outside world. Open a terminal window, switch to root using 'su' and use the 'ifconfig' command to view your assigned IP address. Still in the terminal window use the 'fdisk -l' command to ensure your HDD is available for use. If you're satisfied that your Fedora Live system is functioning properly, double click on the INSTALL icon to begin the installation of Fedora 13 onto your HDD. Perform your installation following these guidelines: wherever possible select the default options set Toronto as your time zone let Fedora configure your whole disk set the root password create a user named 'joker' After completing phase I of the installation, remove the Live CD and reboot from your HDD to complete phase II of the installation. Login as user 'joker' and open a terminal window. Then use 'su' to become root and run the 'yum update' command. Logout when done. Note, you may have to reboot after all updates have completed. Now that your system is up to date, again login as user 'joker' and do the following: Verify that your system date and time are correct. If not then set the correct system date and time. Verify that your network is functioning. Run and record the output of the 'df -hT' command. Run and record the output of the 'cat /etc/fstab' command. Run and record the output of the 'cat /etc/issue' command. Run and record the output of the 'uname -a' command. At this point you have a basic Fedora 13 installed and updated. All the rest of our labs will assume you have this basic system running. If, for any reason, your system becomes corrupted during the semester, you'll have to redo this lab to be able to continue with the remaining uncompleted labs.
