Difference between revisions of "OPS535-vl-lab-nfs"
(→Background) |
(→Investigation 1: VMs Configuration) |
||
| Line 56: | Line 56: | ||
|} | |} | ||
| − | + | === Task 1 : setup and configure VM1 === | |
| + | * ssh to your VM1 from matrix | ||
| + | <pre> | ||
| + | ssh -p 9141 student@ops535.myvmlab.senecacollege.ca | ||
| + | </pre> | ||
| + | * confirm the IP address on the network dev 'ens192'. | ||
| + | * run the 'nmtui' command under sudo and configure '''ens224''' with the appropriate IP address (192.168.xx.1) as shown. | ||
==Investigation 2: Control Workstation Configuration== | ==Investigation 2: Control Workstation Configuration== | ||
Revision as of 19:19, 30 May 2021
DO NOT USE - Work in Progress DO NOT USE - Work in Progress
Contents
OPS535 Lab 2 (using Virutal Lab)
Objectives
- Setup and configure your assigned VMs in the OPS535 Virtual Lab for this lab, future labs, and assignments
- Configure one of the VMs as your control workstation for remote administration tasks
- Create and deploy remote administration scripts using bash/ansible
Pre-Requisites
- Has access to Seneca VPN, and matrix.senecacollege.ca
- Complete the collection of baseline information on your assigned VMs (VM1, VM2, VM3, and VM4)
- Complete the Lab 2 - NFS lab on your home VMs
Investigation 1: VMs Configuration
Background
You have ssh access to your assigned VMs from matrix.senecacollege.ca using the port numbers, user name, and the corresponding password given on Blackboard via the router ops535.myvmlab.senecacollege.ca. The access router will map the ports (9xxy) to the corresponding internal IP addresses (172.20.xx.y) of your VMs, where 'xx' is you assigned network number, and 'y' is the VM number. The following are the port mapping and the network interfaces on each VM:
| VM | Port | ens192 ip | ens224 ip | ens256 ip |
| VMy | 9xxy | 172.20.xx.y | 192.168.xx.y | ---- |
| VM1 | 9141 | 172.20.14.1 | 192.168.14.1 | do-not-use |
| VM2 | 9142 | 172.20.14.2 | 192.168.14.2 | none |
| VM3 | 9143 | 172.20.14.3 | 192.168.14.3 | none |
| VM4 | 9144 | 172.20.14.4 | 192.168.14.4 | none |
Task 1 : setup and configure VM1
- ssh to your VM1 from matrix
ssh -p 9141 student@ops535.myvmlab.senecacollege.ca
- confirm the IP address on the network dev 'ens192'.
- run the 'nmtui' command under sudo and configure ens224 with the appropriate IP address (192.168.xx.1) as shown.
Investigation 2: Control Workstation Configuration
Perform the following steps on VM1 as root:
Investigation 3: Scripts for remote administrations
Task 1
Using bash scripts
Task 2
Using Ansible Playbooks
Completing the Lab
Follow the instructions on blackboard to submit the lab.
