Difference between revisions of "X-Gene Information"
Chris Tyler (talk | contribs) (→Default Linux Installation) |
Chris Tyler (talk | contribs) (→Default Linux Installation) |
||
| Line 6: | Line 6: | ||
The systems ship with uBoot in SPI flash with console on serial /dev/ttyS0 at 115200/8/n/1 | The systems ship with uBoot in SPI flash with console on serial /dev/ttyS0 at 115200/8/n/1 | ||
| − | == Default Linux Installation == | + | == Default Linux Installation (Factory Image) == |
User/pass: root/root | User/pass: root/root | ||
Revision as of 11:49, 6 August 2014
Basic information about the X-Gene Servers
Contents
Boot Software
The systems ship with uBoot in SPI flash with console on serial /dev/ttyS0 at 115200/8/n/1
Default Linux Installation (Factory Image)
User/pass: root/root
User/pass: default/NULL
~800MB
IP Address is preset to 10.x.x.x
Ethernet port assignments
With the default Linux installation:
- eth0: 1GBE upper-right corner (above USB ports)
- eth1: 1GBE lower-left corner
- eth2: 1GBE upper-left corner
- eth3: 10GBE sfp+
All four ports have been confirmed to work. iperf reports 9.41 GB/s on the 10GBE port when directly connected to another X-Gene.
IP Information
These machines are currently connected to Iraq, with static IPs on the eth0 mac addresses.
Iraq has the corresponding hostnames red, blue, and green assigned in /etc/hosts (these names match the ethernet cable colours).
