Difference between revisions of "X-Gene Information"
Chris Tyler (talk | contribs) |
Chris Tyler (talk | contribs) (→Ethernet port assignments) |
||
| Line 18: | Line 18: | ||
With the default Linux installation: | With the default Linux installation: | ||
| − | eth0: 1GBE upper-right corner (above USB ports) | + | * eth0: 1GBE upper-right corner (above USB ports) |
| − | eth1: 1GBE lower-left corner | + | * eth1: 1GBE lower-left corner |
| − | eth2: 1GBE upper-left corner | + | * eth2: 1GBE upper-left corner |
| − | eth3: 10GBE sfp+ | + | * eth3: 10GBE sfp+ |
All four ports have been confirmed to work. <code>iperf</code> reports 9.41 GB/s on the 10GBE port when directly connected to another X-Gene. | All four ports have been confirmed to work. <code>iperf</code> reports 9.41 GB/s on the 10GBE port when directly connected to another X-Gene. | ||
Revision as of 15:07, 9 July 2014
Basic information about the X-Gene Servers
Boot Software
The systems ship with uBoot in SPI flash with console on serial /dev/ttyS0 at 115200/8/n/1
Default Linux Installation
User/pass: root/root User/pass: default/NULL
~800MB
IP Address is preset to 10.x.x.x
Ethernet port assignments
With the default Linux installation:
- eth0: 1GBE upper-right corner (above USB ports)
- eth1: 1GBE lower-left corner
- eth2: 1GBE upper-left corner
- eth3: 10GBE sfp+
All four ports have been confirmed to work. iperf reports 9.41 GB/s on the 10GBE port when directly connected to another X-Gene.
DHCP
DHCP can be invoked with "dhcp eth0" from the serial port.
These machines are currently connected to Iraq, with static IPs locked to the eth0 mac addresses.
Iraq has the corresponding hostnames red, blue, and green assigned in /etc/hosts (these names match the ethernet cable colours).
