View source for NAD810 LAN Setup

<span style="background: #ffff00">'''Note!''' Need to convert this page to task page format</span>

End-node
Host A / Host B / Host C

* Stop the dhclient and/or NetworkManager
* Host A: IP 10.0.0.1 / MAC xx:xx:xx:xx
* Host B: 10.0.0.2 / MAC
* Host C: 10.0.0.3 / MAC

Gateway
* Stop the NetworkManager
* Run dhclient on the external interface
* Assign 10.0.0.254 to the internal interface

Task 0: collect the MAC addresses on all the machines

Task 1: To find out which network interface on the gateway is connected to the LAN

* boot up and configure end-nodes
* nics=$(/sbin/ifconfig -a | grep eth | awk '{print $1}')
* assign 10.0.0.254 to the first device
* ping host A or host B, or host C
* check for result
* assgin 10.0.0.254 to the second device if the first one failed

----
Here's a skeleton of a script to start us off. I'm missing most of the syntax and it has lots of pseudo-code, but the idea is there - scarter4: 
   #!/bin/bash
   
   ## Stop the dhcpclient
   service stop dhcpclient
   ## Grab a list of eth devices
   nics=$(/sbin/ifconfig -a | grep eth | awk '{print $1}'
   ## Assign IP to each device w. loop
        ## start loop
        ifconfig $nic 10.0.0.254 netmask 255.0.0.0
        ## Ping, did it work?
        ping -c 1 10.0.0.1
        if (echo $?)
        then
                break
        else
                null
        ## close loop here
   ## grab a list of MAC addesses
   ifconfig -a | grep HWaddr | awk '{print $5}'


Task 2: Configure route(s)

[[Category:LUX]][[Category:NAD810]]